Common questions about the sound setup.
To ask a question, use the commenting section at the bottom of this page.
Currently there is no mapped connection between the QU-32 and the iMac. Lights are controlled remotely by a MIDI network connection from the stage, or manually by choosing a pre-set in the DMXIS software.
Set the AFL Output setting to OFF in the PAFL settings screen and you'll hear everything pre-fader. This allows you to listen to whatever is being sent to the board without sending it to the DSP. See page 22 of the QU-32 Manual.
FOH stands for Front of House. Draw a vertical boundary from the apron of the stage to the ceiling. Anything from that point to the back of the sanctuary is considered Front of House.
The apron is the part of the stage that curves. Draw a line parallel to the back of the stage from where the curve stops across the stage. Anything in front of that line is the apron.
The DSP is the Digital Signal Processor. We currently use a Rave522ua digital signal processor to route ALL of the building's audio feeds to either the Mains or the Foyer / Lobby.
[audio setup checklist here]